Remootio functions best if the status sensor is also installed and it is enabled in the app. In this tutorial we will explain the operating principle of the sensor and give a few examples on how to install it.

How does the sensor work?

The sensor has two parts: 

  • Wired part (has 4 meters long cable), which is essentially a switch 
  • Magnet part (this has no wires)

When the magnet gets close to the switch, the switch closes and when them magnet is not near the switch it is open. Remootio can check if the switch is open or closed so essentially it checks if the magnet is near the switch (wired part) or not.

Remootio sensor

This means that the sensors need to be mounted in a way that:

  • The wired part is in fixed position and the wire is connected to Remootio’s status sensor input
  • The magnet is mounted on a moving part of the gate/garage door and the magnet aligns with the switch either when the gate is fully open or fully closed

The maximum range of the sensor is approximately 4 centimeters (1.57 inches).

Double-sided tapes are also provided for the sensors, which makes them easier to install. First apply the adhesives to the sensor, and then use it to mount the sensor on the gate or garage door

double-sided tape adhesive Remootio sensor

Step 1) Mounting the sensor

Installation example: Garage door opener

In this example the wired part (B) is mounted on the rail and the magnet (A) is mounted on the moving motor. In the fully open position the magnet aligns with the wired part as seen in the picture below.

An alternative installation is when the two align in the fully closed position. This can be achieved by placing the wired part farther from Remootio along the rail and adjusting the magnet accordingly.

garage door opener Remootio installation

Installation example : Swing gate opener

In this example both parts of the sensor are installed onto a wing of the swing gate. The wired part (B) is installed on the wing closer to the Remootio device.

Remootio swing gate opener installation

Installation example : Sliding gate opener

In this example the wireless part of the sensor is installed under the gear rack and the the wired part (B) is placed on the plastic enclosure of the gate motor in which the Remootio is installed.

Sensor installation on Sliding Gate

Step 2) Wiring the sensor into Remootio

The two cables coming from the wired part must be connected to terminals GATE STATUS INPUT – 4 of the Remootio device. The order of the wires doesn’t matter.

Remootio pinout diagram

Step 3) Enabling the sensor in the app after installation

After installing the sensor, you still need to enable in the app.

To do this swipe to your Remootio device and make sure you are connected to it. Since you have not enabled the sensor yet it will show no sensor.

Remootio app connected to device

Tap on the settings icon in the bottom right corner, scroll down to Gate status sensor and tap on it.

Remootio app settings menu gate status sensor option

On the screen that opens tap on Enable sensor interface. After this the main screen of the app will show the status of the gate or garage door.

Remootio sensor enable interface
Remootio app gate open

If the status shown by the app is always the opposite of the real status, just enable the Flip logic option in the Gate status sensor menu.